Description
The Eclipse i-Series model #9800i is one of the many new Intelligent Flushing & Monitoring Stations Kupferle offers to maintain safe residual levels and remove DBPs from consumers’ water. This permanently installed station incorporates a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule. Using the Programmable Logic Control (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time and a maximum flushing duration. The unit will then operate under these parameters and will flush when detected residuals are below minimum prescribed levels and flush only the exact amount of water needed until desired residuals are attained. All residual and flushing data is recorded and can be transferred to Microsoft Excel via a micro-SD card or can be transmitted using a SCADA system. Unit is fully maintainable from above ground.
Unit is self-powered incorporating a water turbine and a 24VDC battery bank (no outside power source needed). The unit uses any flushed water to run the turbine which charges the batteries that provide power to the analytical equipment. Additional analyzers/sensors can be incorporated including, but not limited to: temperature, pH, psi, turbidity, conductivity and ORP.
Cold climate units feature a thermal enclosure with an insulation rating of R-9 and is equipped with a 250-watt heater/fan and four zone thermostats. Sampling lines are heated using self-regulating heat trace. Unit is fully maintainable from above ground.
Flushing units have a thermal enclosure with an insulation rating of R-9 and unit can be programmed to flush when temperatures fall below 40⁰F.
Upon ordering you will be contacted with an estimate based on your unique specifications. For immediate assistance, you may call 205-669-4535 or email ronnie@silverssales.com.
Reviews
There are no reviews yet.