Eclipse #9800i- Intelligent Automatic Flushing Station

$0.00

The Eclipse i-Series model #9800i is one of the many new Intelligent Flushing & Monitoring Stations Kupferle offers to maintain safe residual levels and remove DBPs from consumers’ water. This permanently installed station incorporates a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule. Using the Programmable Logic Control (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time and a maximum flushing duration. The unit will then operate under these parameters and will flush when detected residuals are below minimum prescribed levels and flush only the exact amount of water needed until desired residuals are attained. All residual and flushing data is recorded and can be transferred to Microsoft Excel via a micro-SD card or can be transmitted using a SCADA system. Unit is fully maintainable from above ground.

Upon ordering you will be contacted with an estimate based on your unique specifications. For immediate assistance, you may call 205-669-4535 or email [email protected].

Description

The Eclipse i-Series model #9800i is one of the many new Intelligent Flushing & Monitoring Stations Kupferle offers to maintain safe residual levels and remove DBPs from consumers’ water. This permanently installed station incorporates a built-in chlorine analyzer to measure and record disinfectant residual levels based on a programmed sampling schedule. Using the Programmable Logic Control (PLC) interface, users can input minimum and desired residual levels, an initial blow-off time and a maximum flushing duration. The unit will then operate under these parameters and will flush when detected residuals are below minimum prescribed levels and flush only the exact amount of water needed until desired residuals are attained. All residual and flushing data is recorded and can be transferred to Microsoft Excel via a micro-SD card or can be transmitted using a SCADA system. Unit is fully maintainable from above ground.

Cold climate units feature a thermal enclosure with an insulation rating of R-9 and come equipped with 150 Watt heater/fan and four zone thermostats (requires 120VAC line power). Sampling lines are heated using self-regulating heat trace. Unit is self-draining, non-freezing based on depth of bury.

The warm climate unit is housed in a UV-resistant lockable enclosure and requires 120VAC line power or a 24VDC solar panel power source.

Upon ordering you will be contacted with an estimate based on your unique specifications. For immediate assistance, you may call 205-669-4535 or email [email protected].

Additional information

Climate

Warm, Cold

Reviews

There are no reviews yet.

Be the first to review “Eclipse #9800i- Intelligent Automatic Flushing Station”